Appliances make life easy, but when they break down, the amount of frustration they can present is impossible.
When you’re checking your appliance for errors, sometimes the code might be too much involving, and you could be wondering how exactly to go about it.
While they are engineered to have a smooth user interface, appliances can sometimes lead you to stray as you struggle to repair a relatively simple problem.
Unlike the past, where dryers used to stop working without displaying any error codes, current-day engineers have gone a notch higher in designing components that can detect errors inside the appliance and display corresponding error codes.
However, an error code would not conclusively give you a solution since you’ll have to figure out what it means and how to go about the repair process.
The great news is that we’ve compiled a comprehensive set of information about the e64 error code on the Electrolux dryer.
This is one of the most common dryer error codes which points to a damaged heater’s wiring system or the actual heating element.
At a glance, the error code e64 on the Electrolux dryer means that you have a shorted heating element.
Let’s take a look.
Possibly damaged parts
- Wire harness
- Heating element
Checking for the error
Disconnect from the dryer from the mains power supply to avoid short-circuiting then check the wire harness connections joining the heating element and the electronic control board.
If there are any loose connections, reconnect the wires, but if the wire harness is damaged, you might have to replace it.
Check the heating element for any damage then replace it if it’s broken.
If there isn’t any apparent damage to the heating element, use an ohmmeter or a multimeter to check it for continuity.
Remember to check the heating element if it’s electrically open, after which you replace it if that’s the case.
Stepwise guide on replacing a heating element in an electric dryer
TH heating element is the source of the dryer’s heat; hence you should check it if the air in the dryer doesn’t get warm.
Check the heating element for signs of breaks or damage in the coiled part. If you notice any cracks or flaws, replace it with a manufacturer-approved replacement component.
To replace it when damaged, use the following steps:
- Unplug the dryer from the mains power connection
- Remove the back panel by using a ¼-inch nut to unscrew the back panel.
- Disconnect the wires after locating the heating element near the bottom of the dryer. If you think you might forget the initial connection pattern, take a photograph from which you’ll refer.
- Remove the heating element by gently pulling it off from the heater box
- Transfer the high-limit thermostat from the current element and put it on the new one.
- Position the new heating element inside the compartment.
- Reconnect the wires to their original state
- Reattach the back panel
- Connect the power supply to the dryer.
On a concluding note, remember to use all the safety equipment since reconnecting disconnected wires can be hazardous if not done correctly.