ge profile, top load washer heat sink: over temperature, inverter over temperature, how to fix?
In order to protect the inverter, the washer will turn off automatically and the large ge profile, top load washer heat sink: over temperature, inverter over temperature, how to fix? will appear. The inverter will reset automatically after cooling down, or you can reset it by unplugging it for 10 seconds.
Ge Profile front load washer heat sink: GE Profile top load washer. Over temperature. Overheat. Overheating. How to fix. How to fix over heat. How to fix overheat. GE Profile top load washer overheat. GE Profile top load washer over temperature. GE Profile top load washer inverter board.The heat sink is a heat exchanger located on the back of the inverter inside the back of the washer. The heat sink is responsible for transferring the heat from the inverter to the external environment. If the heat sink is not functioning properly, the inverter will overheat and shut down.
If your GE Profile washer is running but not agitating, the problem is usually a failed or failing Heat Sink. This is a simple fix for anyone with a little common sense and patience.
First, check to see if the filter is clogged. If it is, clean it or replace it. Make sure you have a clean water supply as well. Then check the drain hose to make sure it is not kinked. If it is, remove the kink. If everything is clear, then check the over temperature sensor.
Unplug the washer. Remove the rear kick plate by opening the top of the washer and removing the two screws at the top of the kick plate. Remove the kick plate and set it aside. Open the door of the washer. Remove the two screws that hold the lower panel to the washer and set the panel aside.