Whirlpool Washer Error Code Dr

Whirlpool Washer Error Code DR

Whirlpool washer error code dr

Malfunction of the drain system is brought about by various reasons. Most of its causes do not require the intervention of the specialist when to solve the error. First of all, it is important to follow the instructions whenever you are draining water. Also, pull the laundry out of the appliance then perform the proceeding steps.

Check the control module

Turn the device off from the network for approximately 10 to 15 minutes. This is one way of rebooting the electronic controller of the whirlpool washer. Switching would be expected to resume work to normal mode, especially when there is an accidental failure of a control module. Eventually, error code dr will disappear from the display.

Check the drain pump contacts

A washer can be exposed to external influences such as transportation and rearrangement. Incorrect wire connections between a drain pump and an electronic controller may break. Therefore, pressing them more tightly between the point of contact perhaps can help to fix the problem.

Check the drain hose

Make sure the drain hose of your washing machine is not bent. Generally, bends can be avoided during operation by installing all the parts correctly. Most manufacturers apply this rule to long tubes, which are more difficult to be fastened in the correct position. Also, remember to check the clogging in the hose.

Check the drain filter

Rinse the drain filters to eliminate the possible clogging. It can usually be found on the flap at the front in the lower right corner. You can turn the filler counterclockwise and then pull it out. If the water leaks from the formed hole, then the machine is okay.

Checking the point of connection to the sewer

Check and rinse the siphon that forms the connection between the sewer system and the drain hose. One way of checking it is by disconnecting the drain hose from the sewer and directing it to any container such as basin. If the washer drains operate and drain water after launch, then the device is in order. The malfunction can be done away by providing a thorough sewer cleaning. Typically, if the error code dr fails to disappear even after checking the above-discussed procedure, the washer would require professional assistance.