Electronic equipment like the Frigidaire dryer is meant to make life easier and more comfortable.
When you have a mammoth of things to do on your table, and your dryer suddenly stops functioning, it could be a devastating blow.
Firstly, the machine communicated the internal problem using an error code that you need to unravel.
Admittedly, cracking the Frigidaire affinity error codes dryer is a daunting task and only half the battle of what you have to go through.
If the dryer has stopped functioning completely, chances are there could be an internal problem that the internal computer has identified, rendering the machine useless.
In this piece, we’ll help you identify the meaning of different Frigidaire affinity front load dryer error codes, after which you’ll troubleshoot the error.
E10 or E11/E12: Communication Error In The Electronic Control Board
Disconnect the dryer from the mains supply for five minutes to reset the control. Reconnect the dryer and start it.
If the code appears, you may have to replace the entire electronic control board.
E24: Error in The Thermistor
Disconnect the dryer than check if the resistance of the temperature sensor is around 50k Ohms. If not, replace it.
E25: Thermistor Error
disconnect the dryer from the mains power supply and check if the resistance is 50,000 Ohms. If it’s defective, replace it.
E4A: Prolonged Dry Time
This error means the standard dry time of the cycle has been exceeded, and it usually shows that the heating system has a problem.
Unplug the dryer and inspect the gas burner or the heating element for defects. If you see signs if any damage, replace the defective components.
E5B: No Heat
The heating system could be damaged, or the gas supply cut-off valve could be fully open.
Disconnect the dryer and inspect these heating components to check if they’re okay.
E68: A Key Is Stuck On the Electronic Control Board
You might have to replace the electronic control board if there is a stuck key inside.
E8C: high-limit trips in the thermostat
If the exhaust vent has any blockage or the dryer overheats, the high limit thermostat could trip.
Inspect the exhaust vent for any blockages and check whether the electronic control board is defected, then replace it if that’s the case.
EAF: failure of the electronic control board
Unplug the dryer from the mains supply for five minutes to reset the control board. Plugin the dryer to restart the cycle, and if the code appears, replace the entire electronic control board.
The common symptoms of a dryer that may precede the error code are that it won’t start, or that it makes much noise or vibrates excessively when working.
Overall, make sure to exercise adequate precaution when working with these dryers since opening the internal components could be dangerous if you don’t have the right expertise.